Tarp Hook
Source: Thingiverse by Norwegian1
The Tarp Hook is a free printable 3D model from Thingiverse by Norwegian1. Handy and very printable small hook designed to fit in a 12mm (1/2 inch) wide tarp grommet hole. You can download the STL file from the original listing below and print it at home.
About this model
Handy and very printable small hook designed to fit in a 12mm (1/2 inch) wide tarp grommet hole. Just a handy hook when you want something nicer than just a screw or nail poking out. You can angle it however you want. Tightening the screw will prettty much lock it into place. Once in place you can easily hook and unhook the tarp. Hung a tarp in front of my porch. Held up to pretty decent wind no problem. Surprisingly strong. Does not unhook by itself when tarp is yanked by wind, but easy to do by hand. Slide buckle over the round butt of the hook and then up. Hang buckle ring edge on protrusion and swing around again to hook it on. Even unhooked the top using a stick, no problem. Fits countersunk wood screws with 8mm wide head (5/16th"), just try stuff out. I'm sure you got some laying aro…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Tarp Hook is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Norwegian1.
- Who made this model?
- Designed by Norwegian1, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Tarp
