FamiCoun - Famicom Front Expansion for NES & SNES Controller
Source: Thingiverse by TheJeffChen
The FamiCoun - Famicom Front Expansion for NES & SNES Controller is a free printable 3D model from Thingiverse by TheJeffChen. Here is my design of an expansion to connect NES and SNES controller to the front port of a Nintendo Famicom. You can download the STL file from the original listing below and print it at home.
About this model
Here is my design of an expansion to connect NES and SNES controller to the front port of a Nintendo Famicom. It makes the Famicom look like a Countach in the front. Hence the name of this project. The player 2 NES port supports the Zapper, as shown on the shell. When you use a SNES controler, Y is B and B is A. ===Prints=== You need to print the front jacket, the plugs and the back. The orientation should be pretty self-explanatory when you put them into the slicer. Remember to set outer wall line width to 0.3mm for the plug at least. Otherwise you might not have round holes but instead have gaps for each of the pin (not really an issue, just bad looking). Support is required for the front jacket. After the print is done, make sure you enlarge the holes for the NES plugs with a 9/64 drill…
Frequently asked questions
- Is this 3D model free to download?
- Yes. FamiCoun - Famicom Front Expansion for NES & SNES Controller is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by TheJeffChen.
- Who made this model?
- Designed by TheJeffChen, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in FamiCoun
