93-97 Del Sol Targa Top Roof Latch Handle (both sides)
Source: Thingiverse by Jamie-Clay
The 93-97 Del Sol Targa Top Roof Latch Handle (both sides) is a free printable 3D model from Thingiverse by Jamie-Clay. Had one of these suckers break on my Del Sol the other day so I whipped up this replacement. You can download the STL file from the original listing below and print it at home.
About this model
Had one of these suckers break on my Del Sol the other day so I whipped up this replacement. There is a knurled steel center from your old lever you will need to insert into the pivot for the lever. I found the best approach to getting the lever aligned was to put the nurled steel center onto the latch axle first then push fit the printed lever onto it. You can either put the cap on before or after inserting the lever onto the axle. I printed it up at .2mm layer height with 100% infill. I also print them with supports to give the visible surface the best finish. If you want to play around with the design here is the fusion file
Frequently asked questions
- Is this 3D model free to download?
- Yes. 93-97 Del Sol Targa Top Roof Latch Handle (both sides) is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Jamie-Clay.
- Who made this model?
- Designed by Jamie-Clay, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in 93-97
