Amiga 500 gotek mount with oled and potentiometer
Source: Thingiverse by Egond8
The Amiga 500 gotek mount with oled and potentiometer is a free printable 3D model from Thingiverse by Egond8. I couldnt find a mount for my gotek with both oled and potentiometer that would not need any modifications on the amiga, so i designed a support that fits those requirements. You can download the STL file from the original listing below and print it at home.
About this model
I couldnt find a mount for my gotek with both oled and potentiometer that would not need any modifications on the amiga, so i designed a support that fits those requirements. This mount uses the original stands for the floppy drive. Everything is designed to screw into the printed holes, no drilling or other screws required. The gotek is from amigastore.eu, it has to be taken out of its original casing, be careful while disassembling the oled not to rip the ribbon cable since the glue holding the oled screen was also touching the ribbon cable. The oled screen needs to be glued to the mount, preferably using hot glue Printed on a Bambulabs A1 with 0.2mm layer height using PLA
Frequently asked questions
- Is this 3D model free to download?
- Yes. Amiga 500 gotek mount with oled and potentiometer is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Egond8.
- Who made this model?
- Designed by Egond8, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Amiga
