DJI Phantom 3 / Inspite 1 Antenna Range Extender
Source: MyMiniFactory by MIke Warden
The DJI Phantom 3 / Inspite 1 Antenna Range Extender is a free printable 3D model from MyMiniFactory by MIke Warden. This easy-to-print Range Extender will extend the range of your DJI Phantom 3 or DJI Inspire 1 considerably. It slips easily onto the standard un-modified DJI Controller. You can download the STL file from the original listing below and print it at home.
About this model
This easy-to-print Range Extender will extend the range of your DJI Phantom 3 or DJI Inspire 1 considerably. It slips easily onto the standard un-modified DJI Controller Antennas and can be quickly installed or removed with one hand – even when your quadcopter is airborne. The Range Extender was created using accurate parabolic curves, and with the antenna mounts centered at the parabolic focal points to maximize signal gain. The only consideration for using this parabolic reflector effectively (and any other high-gain antenna, for that matter) is that you ensure your antenna is squarely facing the quadcopter. Thanks to DJI, that’s very simple, even when your quadcopter may be out of your direct sight. Simply note the position of the green line that appears on your DJI Pilot or DJI GO a…
Frequently asked questions
- Is this 3D model free to download?
- Yes. DJI Phantom 3 / Inspite 1 Antenna Range Extender is free to download from MyMiniFactory. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MyMiniFactory, not by Thinger. We link you directly to the original listing by MIke Warden.
- Who made this model?
- Designed by MIke Warden, published on MyMiniFactory. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
