Arduino Mega 2560 Snug Case
Source: Thingiverse by Esquilo
The Arduino Mega 2560 Snug Case is a free printable 3D model from Thingiverse by Esquilo. A snug fitting case for the Arduino Mega 2560 with screw board mounts and a snap top. You can download the STL file from the original listing below and print it at home.
About this model
A snug fitting case for the Arduino Mega 2560 with screw board mounts and a snap top. Shields may be installed over the top of the case. There are four holes on the top to view the four LEDs on the Arduino board. These holes can accommodate Bivar PLP2-250 light pipes for a more polished look. The screws for the Arduino board are #2 x 1/4" thread rolling screws. This case was derived from my Arduino Uno Snug Case. For the Raspberry Pi, see my Raspberry Pi Snug Case.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Arduino Mega 2560 Snug Case is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Esquilo.
- Who made this model?
- Designed by Esquilo, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Arduino
