Hatchbox Spool Drawers
Source: Thingiverse by bbraun
The Hatchbox Spool Drawers is a free printable 3D model from Thingiverse by bbraun. This design was inspired by Skalla_J's spool storage boxes, but for Hatchbox spools. You can download the STL file from the original listing below and print it at home.
About this model
This design was inspired by Skalla_J's spool storage boxes, but for Hatchbox spools. The hatchbox spools are roughly the same outer diameter, but the inner diameter is different from the original design. Additionally, the hatchbox spools have four sets of holes for holding the end of the filament. This design uses those holes for the drawer hinges, so no drilling is necessary. For the hinges, I use 6-32 threaded rod cut to approximately 67mm in length. Like Skalla_J's design, these thread into the drawers, with a small amount protruding from the top and bottom. The rod should thread somewhat securely into the drawer. I put the end of the threaded rod into the chuck of a power drill and used that to thread the rod into the drawer. The protruding rod ends fit into the existing holes around t…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Hatchbox Spool Drawers is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by bbraun.
- Who made this model?
- Designed by bbraun, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
