HyperCube printable interlocking Frame
Source: Thingiverse by jh1985
The HyperCube printable interlocking Frame is a free printable 3D model from Thingiverse by jh1985. Completely printable frame for Hypercube. You can download the STL file from the original listing below and print it at home.
About this model
Completely printable frame for Hypercube. As loing as you have 177mm height. Based off tech2c recomended measurements. *designed to print with my lasercut i3 with e3d x179 y190 z180 - Print with a 5 line or more brim. -Print Settings -use concentric infill unless printing solid. If solid use any pattern. -0.3mm layer height or less. 0.3 used in the pictures -55mm sec speed or less. Seems to get problems faster. Your printer may be different. -Best way to attach together so far wIth PLA 1. Sand your z seam from the square pin so you have a nice fit. Make sure its flush before you glue. No gaps. 2. Use CA or epoxy Very lightly. Press firmly together. 3. Fuse or melt using a heat gun at 350 deg. I use a fine tip so i only melt a small amount. Place part on a flat surface lke your build plate.…
Frequently asked questions
- Is this 3D model free to download?
- Yes. HyperCube printable interlocking Frame is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by jh1985.
- Who made this model?
- Designed by jh1985, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in HyperCube
