Death Star Grinder
Source: Thingiverse by 3Dash
The Death Star Grinder is a free printable 3D model from Thingiverse by 3Dash. Death Star grinder with small tripod preventing it from rolling away. You can download the STL file from the original listing below and print it at home.
About this model
Death Star grinder with small tripod preventing it from rolling away. It consists of 6 3D printed parts, including the display stand, and some electronics I extracted from a small flash light. Most of the parts are screwed together except for the upper and lower part of the grinder these are held together by two magnets (Diameter: 6mm, Height: 3mm). Make sure you glue the magnets in the right direction. The light source is a 3V LED which was soldered to a small PCB but you could also use a regular 5mm diameter LED and use a glue gun to hold it in place. The LED is connected to a 3x1.5V button cell battery (higher than the LED voltage but this is how it was in the flashlight) and is controlled by a slide switch which sticks out at the backside of the death star ( Since you can't apply glue …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Death Star Grinder is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by 3Dash.
- Who made this model?
- Designed by 3Dash, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Death
