Wet Biscuit (uprgrade 2) 3D printed filing jig to create 0.2 mm flats on a 2 mm brass shaft
Source: Printables by Kriseye
The Wet Biscuit (uprgrade 2) 3D printed filing jig to create 0.2 mm flats on a 2 mm brass shaft is a free printable 3D model from Printables by Kriseye. This is to be sure to make the flats at the good places on the propeler shaft. You can download the STL file from the original listing below and print it at home.
On a computer?
Scan with your phone to install the free app.
About this model
This is to be sure to make the flats at the good places on the propeler shaft.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Wet Biscuit (uprgrade 2) 3D printed filing jig to create 0.2 mm flats on a 2 mm brass shaft is free to download from Printables. Open it in the free Thinger app, or use the "Download from Printables" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Printables, not by Thinger. We link you directly to the original listing by Kriseye.
- Who made this model?
- Designed by Kriseye, published on Printables. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models
HPi 911 body 1/10 Exhaust and headlamp mask for vac forming buckets
Thingiverse · DriftSpot
Shibata Infinity Q60 Exhaust 1/10
Thingiverse · DriftSpot
15mm and 20mm magnet spacers for RC body
Thingiverse · DriftSpot
aPlastics e36 rear trim and exhaust
Thingiverse · DriftSpot
Anbernic RG35XX Stand
Thingiverse · ThRiLL_KiLL
Luke's Lightsaber
Thingiverse · Kent_Creates
