Back Horn Speaker V2.0 BL2 - Bluetooth, Active, Passive
Source: Thingiverse by guppyk
The Back Horn Speaker V2.0 BL2 - Bluetooth, Active, Passive is a free printable 3D model from Thingiverse by guppyk. For all those who have been waiting for the 4" version of the V2.0 speaker, it is now online: And so is the new isobaric subwoofer: Check out the full set of stereo components. You can download the STL file from the original listing below and print it at home.
About this model
For all those who have been waiting for the 4" version of the V2.0 speaker, it is now online: And so is the new isobaric subwoofer: Check out the full set of stereo components (and plenty of other stuff): So here it is. Kissing the frog V2.0. This version is a complete redesign, still just as stylish, super cheap, fully printable BUT sounding MUCH better. This back loaded horn Bluetooth speaker uses a 3.3" (as opposed to the original 2 1/2") driver and a USD 1 Bluetooth board and USD 3.5 amplifier. Total cost should be around USD 20. The enclosure with the back loaded horn (please read below if you are not familiar with the concept) is also a complete redesign. However, the concept remains the same. It is like kissing the frog. You kiss that tiny loudspeaker and hope it turns into a prince…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Back Horn Speaker V2.0 BL2 - Bluetooth, Active, Passive is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by guppyk.
- Who made this model?
- Designed by guppyk, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Back
