Speed Square (Metric and Imperial)
Source: Thingiverse by PPep54
The Speed Square (Metric and Imperial) is a free printable 3D model from Thingiverse by PPep54. FIXED MISTAKE!! - As of 11/19/2020, i fixed the dimension of the vertical side as this one was 3mm shorter than the horizontal which caused a difference of 7º on the diagonal. You can download the STL file from the original listing below and print it at home.
About this model
FIXED MISTAKE!! - As of 11/19/2020, i fixed the dimension of the vertical side as this one was 3mm shorter than the horizontal which caused a difference of 7º on the diagonal angle. Sorry about that! Design of a two sided speed square 160mm x 160mm and for the ones that STILL uses imperial, i designed a 6" x 6" version as well. 160mm x 160mm - The upright side goes from 0cm to 15cm, with steps of 2mm. - The upright slot has two features, one makes it easy to scribe lines for steps of 5mm and 10mm, the other is for steps of 2.5mm and 7.5mm. - The bottom slot goes from 3cm to 8.5cm, with steps of 5mm. - The diagonal side are the angle in degrees from 5º to 85º, with steps of 5º. - The diagonal slot are the common rise over a 12 inches run, from 1" to 30". 6" x 6" - The upright side goes from…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Speed Square (Metric and Imperial) is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by PPep54.
- Who made this model?
- Designed by PPep54, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in angle meter
