Is this 3D model free to download?

Yes, Print in Place SD Card Box is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by fugalster, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Print in Place SD Card Box 3D printable model by fugalster

Print in Place SD Card Box

Source: Thingiverse by fugalster

The Print in Place SD Card Box is a free printable 3D model from Thingiverse by fugalster. A simple print in place box to hold eight micro SD cards and one full size SD card. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

5,189 saves Source: Thingiverse Updated 2026-11-01 License: CC-BY-NC · non-commercial 16 makes Category: 3D Printer

Tags: micro SD, Micro SD Card Holder, print in place, sdcard, sd card, SD Card Holder

About this model

A simple print in place box to hold eight micro SD cards and one full size SD card. Includes a satisfying snap closure. Inspired by povsky's linkage box, but redesigned from the ground up to have an optimized lid swing to clear the SD card. If the linkage doesn't move smoothly, adjust the extruder flow rate and try again. There is a bridged gap on the front of the lid, so good cooling is needed. Note: The model has the appropriate tolerances for the motion to be smooth and precise. making the clearances even just 0.05 bigger than they are leaves the lid feeling loose and wobbly. If you're having problems with the pieces fusing together try turning down the extrusion rate/flow multiplier by increments of 5% (this can be done on the printer, no need to reslice). If that doesn't work then you…

Frequently asked questions

Is this 3D model free to download?: Yes. Print in Place SD Card Box is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by fugalster.
Who made this model?: Designed by fugalster, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.