Is this 3D model free to download?

Yes, Cr-10 Filament Sensor Bracket & Tutorial is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by GiantMidgt, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Cr-10 Filament Sensor Bracket & Tutorial 3D printable model by GiantMidgt

Cr-10 Filament Sensor Bracket & Tutorial photo 1

Cr-10 Filament Sensor Bracket & Tutorial photo 2

Cr-10 Filament Sensor Bracket & Tutorial photo 3

Cr-10 Filament Sensor Bracket & Tutorial photo 4

Cr-10 Filament Sensor Bracket & Tutorial

Source: Thingiverse by GiantMidgt

The Cr-10 Filament Sensor Bracket & Tutorial is a free printable 3D model from Thingiverse by GiantMidgt. Overview: I designed a Bracket to hold a filament run-out sensor i bought off ebay. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

1,238 saves Source: Thingiverse Updated 2026-10-31 License: CC-BY · commercial OK 11 makes Category: 3D Printer

Tags: bracket, CR-10, Creality CR-10, filament, Filament Sensor, sensor

About this model

Overview: I designed a Bracket to hold a filament run-out sensor i bought off ebay. When the filament runs out, in this order it will: 1. Pause the print 2. retract filament to stop oozing, 3. move the head away to allow filament change 4. resume back where it initially stopped. Properties: - It slips over the Extruder, and also has a cable holder integrated. - The design allows it so you can use a small amount of PTFE tube to make it easier for the filament to guide into the extruder motor. - Sensor Light up green when there is filament detected You Will Need: -Sensor: AliExpress: -Connectors for Raspberry pi: -RaspberryPi running Octoprint Setup Steps: 1. print out Filament Sensor and Lid 2. Install Sensor inside housing (will be a tight fit) 3. Wire up Sensor to Raspberry Pi. ( follow t…

Frequently asked questions

Is this 3D model free to download?: Yes. Cr-10 Filament Sensor Bracket & Tutorial is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by GiantMidgt.
Who made this model?: Designed by GiantMidgt, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.