Grinder, belt sander
Source: Thingiverse by boris550
The Grinder, belt sander is a free printable 3D model from Thingiverse by boris550. Grinder for the battery of the Makita. You can download the STL file from the original listing below and print it at home.
About this model
Grinder for the battery of the Makita. Printed PETG from FDPlast, layer 0.3, filling 30% triangle. M4 screws. The engine DPM-30-n1-01, was available. Bearing-3 pieces unknown: external -14 mm, internal - 7 mm, height 4 mm. The tape is 330x15 mm, ordered on Ali. The toggle switch is round, although a rectangular one would stand up without problems, but it seemed to me that a round one would be better. The power connector is cable, without a housing. Contact plates for the battery 32x15x0.5 mm, I found a sheet of copper in the bins. Since the grinder was designed manually, and then a platform was attached to it for the battery from the Makita, another cable is needed, short with two dads, there are two power outlets with different polarity on the site, so the reverse was implemented. I don't…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Grinder, belt sander is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by boris550.
- Who made this model?
- Designed by boris550, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in belt sander
