20 mm watch strap and buckle
Source: Thingiverse by robwhi
The 20 mm watch strap and buckle is a free printable 3D model from Thingiverse by robwhi. This is a remix from laird's watch strap and Lindsay Fowler's buckle. You can download the STL file from the original listing below and print it at home.
About this model
This is a remix from laird's watch strap and Lindsay Fowler's buckle. I added a latch and I used a piece of 1.75mm filament for the pin on the buckle. I have made the strap 20mm wide and only 1mm thin since I use Fillamentum flexfill 98A TPU filament, which is rather rigid at 2mm thickness. Printing these (I have used slic3r): Strap: I suggest splitting the file so you print one part of the strap at a time. This reduces stringing. Orient the strap sideways on the print bed. I printed at 020mm layer height with a 2mm brim. Make sure the loops for the pins are printed in a continuous way. Some settings might make the loop part print in little bits. I have modified the buckle side of the strap so that it incorporates a support over the hole where the latch would go. You need to cut this out a…
Frequently asked questions
- Is this 3D model free to download?
- Yes. 20 mm watch strap and buckle is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by robwhi.
- Who made this model?
- Designed by robwhi, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in 20
