Stackable Battery Holders Improved
Source: Thingiverse by KLXL
The Stackable Battery Holders Improved is a free printable 3D model from Thingiverse by KLXL. This is a remix of all three stackable battery holders designed by adoniram plus a new holder I designed for CR2032 coin-shaped batteries. You can download the STL file from the original listing below and print it at home.
About this model
This is a remix of all three stackable battery holders designed by adoniram plus a new holder I designed for CR2032 coin-shaped batteries. The idea was to incorporate other ideas I found in various remixes maintaining the original design as much as possible. I used the solution proposed by 7eggert which adds ramps on both the base and the cover that fix the jams as well as side holes that allow to see if there are still batteries left. I also added the side borders to the end of the tongue to prevent the batteries from falling to the sides. Finally, I redesigned the way the cover is locked to the base at the bottom to facilitate the assembly. Based on my tests, the jam issue is now gone in all containers. This printed very well in PLA as follows: * cover - no supports, face down * label - …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Stackable Battery Holders Improved is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by KLXL.
- Who made this model?
- Designed by KLXL, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in battery holder
