Is this 3D model free to download?

Yes, Civic EG Left Side Vents 52MM Gauge Holder is free to download from Cults3D. Open it in the free Thinger app, or use the "Download from Cults3D" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Cults3D. Use the "Download from Cults3D" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Donbasonia, published on Cults3D. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Civic EG Left Side Vents 52MM Gauge Holder

Source: Cults3D by Donbasonia

The Civic EG Left Side Vents 52MM Gauge Holder is a free printable 3D model from Cults3D by Donbasonia. This gauge holders fits in the left dashboard vent on a civic EG, to install these you need to break off the little air flaps and you'll should still be able to use AC but no. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Cults3D

30 saves Source: Cults3D Updated 2026-09-22 Print time: 10m License: CC-BY-NC-SA · non-commercial Category: Other

Tags: civic, eg, gauges, 52mm, 62mm, eg6, honda, gauge, vent

About this model

This gauge holders fits in the left dashboard vent on a civic EG, to install these you need to break off the little air flaps and you'll should still be able to use AC but no heating anymore, removing the dashboard is HIGHLY recommended, it takes no longer than 10 minutes and it will make the whole process a lot easier, use super glue to secure the gauge holder in place, measurements were taken on a AEM gauge but other 52mm gauges should be able to fit, the 'less tight" version should just fit in the vent but may be lose, you may be able to secure it using double sided tape, i haven't tested that version but the regular version fitted in mine with a little bit of sanding and strength, the gauge should be held in by pressure but if it falls out too easily i recommend putting electrical tape…

Frequently asked questions

Is this 3D model free to download?: Yes. Civic EG Left Side Vents 52MM Gauge Holder is free to download from Cults3D. Open it in the free Thinger app, or use the "Download from Cults3D" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Cults3D, not by Thinger. We link you directly to the original listing by Donbasonia.
Who made this model?: Designed by Donbasonia, published on Cults3D. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.

Similar 3D models in civic

Browse related collections

Free Board Game Inserts & Organizers to 3D Print Free 3D Prints for the Bambu Lab P1S Free 3D Prints for the Prusa MK4 & MK4S Free Home Organization 3D Prints

Gear / Paid link The gear we print with Filament, tools, build plates and the hardware behind the models on Thinger, in one shoppable photo on our Amazon storefront. See the gear → Thinger earns a commission from qualifying purchases made through this link, at no extra cost to you.