Snowball Maker
Source: Thingiverse by jim0089
The Snowball Maker is a free printable 3D model from Thingiverse by jim0089. !!! UPDATE V3 The snowball clips sold are very large and require both hands to operate, which greatly reduces the efficiency: clamp the snow with both hands, release the clip. You can download the STL file from the original listing below and print it at home.
About this model
!!! UPDATE V3 The snowball clips sold are very large and require both hands to operate, which greatly reduces the efficiency: clamp the snow with both hands, release the clip, and hold the snowball with your hands, slowly, too slowly. Use this, insert your thumb into the round hole, clamp the small ball between your index and middle fingers, grab a handful of snow, and a snowball will be formed. Press it with the other hand to make it stronger, and then you can throw it out (pay attention to safety and do not throw it out) Throw the clip out too) One-piece molding, one model is printed directly. After printing, it can be used together. 0.4mm is reserved for the hinge axis. Under normal printing conditions, the two halves will open and close smoothly. It looks a little small for adults, and…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Snowball Maker is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by jim0089.
- Who made this model?
- Designed by jim0089, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in snow
