Logitech c270 CR-10 Camera mount
Source: Thingiverse by DigChaos
The Logitech c270 CR-10 Camera mount is a free printable 3D model from Thingiverse by DigChaos. Update 6-21-2017 ------------------------------- Updated the mount to allow room for swivel. You can download the STL file from the original listing below and print it at home.
About this model
Update 6-21-2017 ------------------------------- Updated the mount to allow room for swivel. The arm would hit the corner before, now it should clear it. The C270 camera mount is attached to the camera using it's own hinge pin. The dual diameter bolt fits through the sliding mount. To remove the original weighted Logitech mount from the camera, use a thin knife to remove the covers over the ends of the hinge pin. You should then be able to use a screwdriver to remove the pin. You may need to push the pin out with a thin screwdriver or similar tool. The printed camera mount will be loose on the hinge. Use a small (M3?) metal washer at one end of the hinge pin, and a very small rubber washer at the other end of the hinge pin. I also made some small improvements on the arm itself. I increased…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Logitech c270 CR-10 Camera mount is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by DigChaos.
- Who made this model?
- Designed by DigChaos, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Logitech
