SKADIS Spool Holder with Label Slot
Source: MakerWorld by Alexey Cluster
The SKADIS Spool Holder with Label Slot is a free printable 3D model from MakerWorld by Alexey Cluster. Just another spool holder for IKEA SKÅDIS — but this one has a dedicated slot for a 12mm TZe tape label. I wanted my filament storage to be a little easier to navigate, so I. You can download the STL file from the original listing below and print it at home.
About this model
Just another spool holder for IKEA SKÅDIS — but this one has a dedicated slot for a 12mm TZe tape label. I wanted my filament storage to be a little easier to navigate, so I added a label holder designed specifically for 12 mm Brother TZe tape. The labels shown in the photos were printed using Panel Label mode with a length of 80 mm. The holder consists of two printable halves that snap together, making it easy to print while keeping support material to a minimum.Each complete holder uses approximately 90 g of filament.PrintingI recommend printing this model in PETG.Supports are required, but they should be quite easy to break away carefully after printing.The two halves are designed to press-fit together. The exact fit may vary slightly depending on the filament, printer, and calibration:…
Frequently asked questions
- Is this 3D model free to download?
- Yes. SKADIS Spool Holder with Label Slot is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by Alexey Cluster.
- Who made this model?
- Designed by Alexey Cluster, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in skadis
