PandaTouch NFC Cover
Source: MakerWorld by Chris
The PandaTouch NFC Cover is a free printable 3D model from MakerWorld by Chris. NFC Cover for PandaTouch This cover for the PandaTouch allows to mount and wire an external PN532 NFC reader. The magnetic dock can still be used, this cover just clamps on the. You can download the STL file from the original listing below and print it at home.
About this model
NFC Cover for PandaTouch This cover for the PandaTouch allows to mount and wire an external PN532 NFC reader. The magnetic dock can still be used, this cover just clamps on the sides of the PandaTouch and leaves the back as is. Check out for a ESPoolBuddy, a low-cost SpoolBuddy addon to Bambuddy, supporting PandaTouch with NFC reader addon! Boost MeDid you enjoy my model? Give me a boost!It's free for you, but means a lot to me showing your appreciation of my work.Thank you! Assembly instructions:Inserts: with the frame face-down, press the M2 inserts into the two PN532 standoffs and the M3 inserts into the two cover bosses.PN532: Screw the board in with its flat side facing forward and the header at the top or bottom.Pads: drop an M3 nut into each slot next to the right wall. Put the pads…
Frequently asked questions
- Is this 3D model free to download?
- Yes. PandaTouch NFC Cover is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by Chris.
- Who made this model?
- Designed by Chris, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in espoolbuddy
