Self Watering Flowerpot 4 quadrants
Source: MakerWorld by scenesandthings
The Self Watering Flowerpot 4 quadrants is a free printable 3D model from MakerWorld by scenesandthings. This was created so that I could put 4 plants in the same pot but keep the root systems separated and save space. You can download the STL file from the original listing below and print it at home.
About this model
This was created so that I could put 4 plants in the same pot but keep the root systems separated and save space. it makes it easier to swap out a plant that dies, but also allows me to collect specific plants like Hoya varieties and save space. I made the wedges just a bit higher than the outer pot including a center raised piece around the central watering hole, to make. it easier to remove the wedges when you want to change the plant or check the water level in the reservoir. I also print out a pot riser which I add to the inside of the pot as needed to add additional support to for the wedges. This will need to be sized based on the size of the pot you print--especially if you scale it – I did not include that here because I am only including the things I designed and that is av…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Self Watering Flowerpot 4 quadrants is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by scenesandthings.
- Who made this model?
- Designed by scenesandthings, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in flowerpot
