CR-10 E3D V6 Fully Automatic Autobed level endstop mod
Source: Thingiverse by Lancer6
The CR-10 E3D V6 Fully Automatic Autobed level endstop mod is a free printable 3D model from Thingiverse by Lancer6. I developed this mod because for some reason I found the capacitive sensor start off great for Auto bed levelling but seem to deteriorate over time for unknown reasons. You can download the STL file from the original listing below and print it at home.
About this model
I developed this mod because for some reason I found the capacitive sensor start off great for Auto bed levelling but seem to deteriorate over time for unknown reasons. The detection drifts would get more and more significant. I tried multiple different sensors and testing conditions. So I came to the conclusion I wanted a physical probe. This is how this mod was born. It uses the stock Z-endstop sensor you just need to extend the wires so it can move with the X carriage. I also didn't like moving it up and down manually so I developed the lifting mechanism to raise at end of bed levelling and to lower after print is complete. Please insert the following start and finishing G-code to your slicer. (PLEASE NOTE: I run all start and end G-code scripts direct from my Octoprint. SO these codes …
Frequently asked questions
- Is this 3D model free to download?
- Yes. CR-10 E3D V6 Fully Automatic Autobed level endstop mod is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by Lancer6.
- Who made this model?
- Designed by Lancer6, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in CR-10
