CR10 Snap Lock Extruder Sleeve
Source: Thingiverse by danbear
The CR10 Snap Lock Extruder Sleeve is a free printable 3D model from Thingiverse by danbear. This is a sleeve that fits over the CR10 extruder preloader that locks the preloader open so you can freely load and unload filament without needing to squeeze the extruder open. You can download the STL file from the original listing below and print it at home.
About this model
This is a sleeve that fits over the CR10 extruder preloader that locks the preloader open so you can freely load and unload filament without needing to squeeze the extruder open the whole time. No post processing required, just slide it over the stock preloader and you're good to go. (need to unload the filament to feed it through a hole in the new part) Leave a comment or a pic, let us know how it fits up. NOTE >> THERE ARE DIFFERENT STOCK ARMS FROM CREALITY THAN MINE AND THEY ARE NOT COMPATIBLE. MAKE SURE YOU EXTRUDER ARM LOOKS CORRECT BEFORE PRINTING. CROSS CHECK AGAINST THE DIMENSIONED OUT PICTURE.
Frequently asked questions
- Is this 3D model free to download?
- Yes. CR10 Snap Lock Extruder Sleeve is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by danbear.
- Who made this model?
- Designed by danbear, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in CR10
