CR-10, OEM Fan, Offset Nozzle, Strong Tabs
Source: Thingiverse by RickB
The CR-10, OEM Fan, Offset Nozzle, Strong Tabs is a free printable 3D model from Thingiverse by RickB. Remix of I printed the original design at 0.2mm layer and during install the mounting tabs cracked. You can download the STL file from the original listing below and print it at home.
About this model
Remix of I printed the original design at 0.2mm layer and during install the mounting tabs cracked. After a few prints i liked the offset nozzle design to blow part cooling air right where it was needed as compared to a couple other popular designs. So in hopes of making it better: I reduced the hole diameter by 0.4mm on diameter ( its just snug on the threads now), I also added 0.5mm to each end of the mounting hole tabs and finally I stretched the small bevel over the whole width of the fan shroud so it was less likely to catch the print if it was going to lift. No Raft required. No Supports required. Prints good at 0.2mm layers. cr-10_oem_fan_nozzle_offset_stonger.stl is the original file. Use Version 2. cr-10_oem_fan_nozzle_offset_stonger_v2.stl added 1-19-2018 Added a even more materi…
Frequently asked questions
- Is this 3D model free to download?
- Yes. CR-10, OEM Fan, Offset Nozzle, Strong Tabs is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by RickB.
- Who made this model?
- Designed by RickB, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in CR-10
