Is this 3D model free to download?

Yes, 6 Cable Organizer and Holder is free to download from MyMiniFactory. Open it in the free Thinger app, or use the "Download from MyMiniFactory" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by MyMiniFactory. Use the "Download from MyMiniFactory" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Cameron O'Neill, published on MyMiniFactory. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

6 Cable Organizer and Holder 3D printable model by Cameron O'Neill

6 Cable Organizer and Holder

Source: MyMiniFactory by Cameron O'Neill

The 6 Cable Organizer and Holder is a free printable 3D model from MyMiniFactory by Cameron O'Neill. This is a two-piece wire holder/organizer which keeps wires from getting tangled or falling over the edge of a table/desk. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from MyMiniFactory

326 saves Source: MyMiniFactory Updated 2026-10-28 License: DOWNLOAD-SHARE-MAINTAIN-LICENSE-CREDIT-REMIX-NONCOMMERCIAL · non-commercial

Tags: office, simple, support-free, desktop, supportless, wire, organizer, wireholder, organization

About this model

This is a two-piece wire holder/organizer which keeps wires from getting tangled or falling over the edge of a table/desk. Print both parts. If the parts don't easily slide together as pictured, light sanding of the edges can make the fit a bit less tight. If you'd like to secure this to a flat surface, such as the edge of a table, I recommend using either velcro or a double sided adhesive tape.

Frequently asked questions

Is this 3D model free to download?: Yes. 6 Cable Organizer and Holder is free to download from MyMiniFactory. Open it in the free Thinger app, or use the "Download from MyMiniFactory" link above to open the original listing.
Where is the STL hosted?: The download is hosted by MyMiniFactory, not by Thinger. We link you directly to the original listing by Cameron O'Neill.
Who made this model?: Designed by Cameron O'Neill, published on MyMiniFactory. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.