Is this 3D model free to download?

Yes, Hairspray Pump is free to download from MyMiniFactory. Open it in the free Thinger app, or use the "Download from MyMiniFactory" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by MyMiniFactory. Use the "Download from MyMiniFactory" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Henry Qiu, published on MyMiniFactory. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Hairspray Pump 3D printable model by Henry Qiu

Hairspray Pump

Source: MyMiniFactory by Henry Qiu

The Hairspray Pump is a free printable 3D model from MyMiniFactory by Henry Qiu. Please read the safety concern section below Most of you have glass beds, and hairspray is one of the most commonly used bed adherence tools. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from MyMiniFactory

721 saves Source: MyMiniFactory Updated 2026-10-11 License: DOWNLOAD-SHARE-MAINTAIN-LICENSE-CREDIT-REMIX-NONCOMMERCIAL · non-commercial

Tags: glass, bottle, can, cap, easy, top, stick, bed, snap, Press, pump, hairspray, glassbed, convenient, spray

About this model

Please read the safety concern section below Most of you have glass beds, and hairspray is one of the most commonly used bed adherence tools. I'm not a fan of removing my glass bed every time I re-apply hairspray so I usually fold a paper towel into a little square, and spray the hairspray onto there, and then wipe it on in a thin layer in the middle of the bed. This has worked great, except I need two hands to do this, and I always end up coating the other hand in hairspray. I was modeled after a can of unscented extra super hold Aquanet, but this has fit with a wide range of compression cans. NOTEIf It doesn't mist out and it ends up streaming out, (the hole may seal due to over extrusion), just take a thin needle or pin and tap it into the hole. I used a 0.5mm needle to enlarge my hole,…

Frequently asked questions

Is this 3D model free to download?: Yes. Hairspray Pump is free to download from MyMiniFactory. Open it in the free Thinger app, or use the "Download from MyMiniFactory" link above to open the original listing.
Where is the STL hosted?: The download is hosted by MyMiniFactory, not by Thinger. We link you directly to the original listing by Henry Qiu.
Who made this model?: Designed by Henry Qiu, published on MyMiniFactory. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.