Dialing Stargate with DHD and Openlock Base
Source: MyMiniFactory by Ilkka
The Dialing Stargate with DHD and Openlock Base is a free printable 3D model from MyMiniFactory by Ilkka. This 120mm Stargate rotates the symbol ring and controls the chevron LEDs based on 7-chevron address, which can be programmed by the DHD button. You can download the STL file from the original listing below and print it at home.
About this model
This 120mm Stargate rotates the symbol ring and controls the chevron LEDs based on 7-chevron address, which can be programmed by the DHD button. The gate rests on 4x6 Openlock base. File Stargate.pdf contains design principles and assembly instructions. See also video Arduino sketch can be found at Thingiverse: I was not able to load .ino file to MyMiniFactory. Advice accepted :) DHD button controls the operation, which has three modes: Dialing is started by short pressing of DHD button – the gate dials a 7-chevron address saved in EEPROM. The gate stays open for 1 minute and then closes by itself. Programming mode is activated by pressing the DHD button for 5 seconds. Then the button is used to control rotation and direction for each of the 7 stages in order to define the address; the add…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Dialing Stargate with DHD and Openlock Base is free to download from MyMiniFactory. Open it in the free Thinger app, or use the "Download from MyMiniFactory" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MyMiniFactory, not by Thinger. We link you directly to the original listing by Ilkka.
- Who made this model?
- Designed by Ilkka, published on MyMiniFactory. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in arduino;
