Spiral Vertical Paper Towel Holder
Source: MakerWorld by Ken Mills
The Spiral Vertical Paper Towel Holder is a free printable 3D model from MakerWorld by Ken Mills. The normal size has a 160mm internal (max roll size) and 32mm post diameter (max hole size). You can download the STL file from the original listing below and print it at home.
About this model
The normal size has a 160mm internal (max roll size) and 32mm post diameter (max hole size). The medium and small sizes are 140mm and 114mm respectively. The jumbo version has a 180mm internal and 38mm post diameter to accommodate larger rolls. After adding the towel roll with the end free, spinning the roll clockwise should automatically feed the end out of the side slot. Tear a sheet off by pulling from the bottom upward and towards the right edge of the slot. Feel free to increase the holder's height. I chose 180mm high to fit my bed, and I don't think I would go much shorted, but I think taller wouldn't hurt. Add three rubber pads or feet to help prevent sliding. I have a spot on my workbench paper towels live, so I just may attach it with some double-sided tape to create a semi-perman…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Spiral Vertical Paper Towel Holder is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by Ken Mills.
- Who made this model?
- Designed by Ken Mills, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Spiral
More from Ken Mills
