Is this 3D model free to download?

Yes, Minolta Camera 16mm Film Cartridge is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by MakerWorld. Use the "Download from MakerWorld" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Aerocats, published on MakerWorld. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Minolta Camera 16mm Film Cartridge 3D printable model by Aerocats

Minolta Camera 16mm Film Cartridge photo 1

Minolta Camera 16mm Film Cartridge

Source: MakerWorld by Aerocats

The Minolta Camera 16mm Film Cartridge is a free printable 3D model from MakerWorld by Aerocats. Minolta Camera 16mm Film Cartridge Printer: Bambu P1PNozzle: 0.4Profile: 0.12mm Fine @BBL P1PFilament: Overture PLA, BlackModel must be printed using a 0.3mm wall width to insure. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from MakerWorld

109 saves Source: MakerWorld Updated 2026-10-12 Print time: 36m Filament: 7 g License: CC-BY-NC-SA · non-commercial ★ 5.0 (4) 70 makes Category: Gadgets & Electronics

Tags: cameraaccessory, 16mm, 16mmfilm, film

About this model

Minolta Camera 16mm Film Cartridge Printer: Bambu P1PNozzle: 0.4Profile: 0.12mm Fine @BBL P1PFilament: Overture PLA, BlackModel must be printed using a 0.3mm wall width to insure that the fit tolerance is maintained.----------------------------------------------------------------------------------------------------------------I have added an image of the cartridge with a strip of flocking tape attached to each side of the film pass through slot. The flocking tape fits just right to stop 99.9% of the light from entering the film cartridge and still allow the film to slide in and out.The flocking tape I used was VCC Flocking Tape [Non-woven Fabric] (FLOCK-1): 1/2 in. x 300 in. (Black)

Frequently asked questions

Is this 3D model free to download?: Yes. Minolta Camera 16mm Film Cartridge is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
Where is the STL hosted?: The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by Aerocats.
Who made this model?: Designed by Aerocats, published on MakerWorld. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.