Bottle dryer (3, 6 and 9 bottle variants)
Source: MakerWorld by matthiasdeblaiser
The Bottle dryer (3, 6 and 9 bottle variants) is a free printable 3D model from MakerWorld by matthiasdeblaiser. Made this because I was frustrated by bottles constantly falling after doing the dishes. You can download the STL file from the original listing below and print it at home.
About this model
Made this because I was frustrated by bottles constantly falling after doing the dishes. This way they can drip all they want without the risk of falling. And they're quickly put aside for when you need some extra roomDesigned for the max print volume of the Bambu Lab X1C with the filament cutter enabled. (no the build surface is not full 256x256mm) and leaving some room for a brim (tabs in this case). I landed on a 235mmx235mm max dimension of the model.A brim caused errors (gcode out of bound or something like that even though the prime lines were even beyond the print) so I made some little bitty tabs that probably don't do much anyway… (it didn't warp on my first try, but is that because of the tabs? no one knows)With a few minutes of shifting the model around I finally landed on this …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Bottle dryer (3, 6 and 9 bottle variants) is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by matthiasdeblaiser.
- Who made this model?
- Designed by matthiasdeblaiser, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in kitchen
More from matthiasdeblaiser
