Bambu clog pusher for hotend
Source: MakerWorld by Print4Gods
The Bambu clog pusher for hotend is a free printable 3D model from MakerWorld by Print4Gods. How to use it:Undo the hot end when cold, you don't want the fan running as it can touch things and break.Beforehand make sure the hot end screws fits in the de-clogger, if not. You can download the STL file from the original listing below and print it at home.
About this model
How to use it:Undo the hot end when cold, you don't want the fan running as it can touch things and break.Beforehand make sure the hot end screws fits in the de-clogger, if not, clean the holes up.it goes without saying that this is best printed in Petg or ABS. PLA is not best around the hot end ;) Slide the piece onto the hot end top and lock in place by sliding the screws in.Now heat up the hot end to a healthy temp like 250c.When it's hot wait an extra 5min for the heat break and the top fins to get to temperature. if that's cold it won't work.Then use the smaller key included with your X1 in the top of the De-clogger and apply pressure holding it like a syringe, mine was quite stuck so it took a good bit but then it went in all the way! Reassemble everything and run a couple load/unloa…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Bambu clog pusher for hotend is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by Print4Gods.
- Who made this model?
- Designed by Print4Gods, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in bambu
More from Print4Gods
