Book stand for heavy books
Source: MakerWorld by levarne.sobotker
The Book stand for heavy books is a free printable 3D model from MakerWorld by levarne.sobotker. By Dawgz This is a remix to Thing # 2777595. You can download the STL file from the original listing below and print it at home.
About this model
By Dawgz This is a remix to Thing # 2777595. The original was okay for paperbacks but didnt do well for heavier or larger hard cover books, especially because of the vertical stabilizer in the middle of the holder.I have copied the stabilizer into two areas where it would serve better use to support larger hard cover books.I have also made the base wider to support the book overall, the portion that holds the pages in place have been extended out a little and the arches have been increase from 36mm to 52mm (holds the pages in place better).** The arches that hold the pages also now have a piece that protrudes out to press down on the pages while the book is in place.The angle of the stabilizers is adjusted 10-15 degrees down to give better visibility to the pages.*Lastly, cut out some port…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Book stand for heavy books is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by levarne.sobotker.
- Who made this model?
- Designed by levarne.sobotker, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in bookholder
