Bambu Poop Chute - Magnet Remix
Source: MakerWorld by asc_ii
The Bambu Poop Chute - Magnet Remix is a free printable 3D model from MakerWorld by asc_ii. This is a remix of the great design of Bambu Poop Chute by Fantasy3DPrintsShopUses 6x3mm magnets to attach the chute to the back of the X1C, P1P or P1S case.No supports are. You can download the STL file from the original listing below and print it at home.
About this model
This is a remix of the great design of Bambu Poop Chute by Fantasy3DPrintsShopUses 6x3mm magnets to attach the chute to the back of the X1C, P1P or P1S case.No supports are required.I printed using these settings:0.4mm nozzle2 layer wallno support10% infillno brimno supportstop surface only ironingadaptive layer height (using the default adaptive layer bambu studio settings)Used 380g of filament and I was able to use ludacris mode after the base layers were printed to decrease the print time.6x3mm magnets are easily sourced from amazon, ebay or aliexpress. I used N45 grade which gives nice attachment strength.The magnets are a tight fit when pushing in. If it feels too tight, use a craft knife to gently scrape, sand or cut away the top of the hole to enlarge slightly. If you make too large…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Bambu Poop Chute - Magnet Remix is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by asc_ii.
- Who made this model?
- Designed by asc_ii, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in bambu
