Is this 3D model free to download?

Yes, Xbox 360 Slim 2.5" SSD adapter is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by MakerWorld. Use the "Download from MakerWorld" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by Austin Vojta, published on MakerWorld. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Xbox 360 Slim 2.5" SSD adapter 3D printable model by Austin Vojta

Xbox 360 Slim 2.5" SSD adapter

Source: MakerWorld by Austin Vojta

The Xbox 360 Slim 2.5" SSD adapter is a free printable 3D model from MakerWorld by Austin Vojta. Adapter that will let you use a 2.5" SSD in a modded Xbox 360 Slim (aka Xbox 360 S). You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from MakerWorld

1,008 saves Source: MakerWorld Updated 2026-10-13 Print time: 2h 47m Filament: 45 g License: CC-BY-NC-SA · non-commercial ★ 4.8 (36) 690 makes Category: Gadgets & Electronics

Tags: ssd, xbox, xbox 360, slim, 360, hard drive, solid state drive

About this model

Adapter that will let you use a 2.5" SSD in a modded Xbox 360 Slim (aka Xbox 360 S). Just slide the drive in, and then plug into your 360. Be sure to pay attention to the orientation of the plug. Includes holes on the back so you can pull this out of the 360 with pliers (or tie a string/ribbon around it), and some thumb cutouts up top for easier drive removal.Note: Should print fine at 200um layers in PLA, but you may need a smaller layer height for materials like ABS/Nylon for the hexagons to come out nicely. No supports needed. Prints vertically, may need a small brim if you bed adhesion isn't great.

Frequently asked questions

Is this 3D model free to download?: Yes. Xbox 360 Slim 2.5" SSD adapter is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
Where is the STL hosted?: The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by Austin Vojta.
Who made this model?: Designed by Austin Vojta, published on MakerWorld. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.