Orange Pi 3 LTS Case for 40mm Fan
Source: MakerWorld by afschuld
The Orange Pi 3 LTS Case for 40mm Fan is a free printable 3D model from MakerWorld by afschuld. This is a remix of ctheroux's excellent Orange Pi 3 LTS Case, which I really liked but thought could use a little flavor. You can download the STL file from the original listing below and print it at home.
About this model
This is a remix of ctheroux's excellent Orange Pi 3 LTS Case, which I really liked but thought could use a little flavor. I changed the size of the fan to 40mm to fit the fans I had on hand, and rounded off the edges and added a cute orange design to the fan shroud.I used these fans here: well as 4 12mm M3 screws and 4 hex nuts for mounting. You'll want to connect the fan to the 5v and ground pins of the GPIO Out, which are the two pins on the right side, one from the top, diagram is here: you used the fan in my amazon link, the fan connector should just slide on with no issue.
Frequently asked questions
- Is this 3D model free to download?
- Yes. Orange Pi 3 LTS Case for 40mm Fan is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by afschuld.
- Who made this model?
- Designed by afschuld, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Orange
More from afschuld
