Filament Spool Holder - Bearings and custom width
Source: Thingiverse by sigshoj
The Filament Spool Holder - Bearings and custom width is a free printable 3D model from Thingiverse by sigshoj. Low profile filament spool holder, for when you want your filament sitting next to your printer, and don't take up a lot of space. You can download the STL file from the original listing below and print it at home.
About this model
Low profile filament spool holder, for when you want your filament sitting next to your printer, and don't take up a lot of space. Use 4 skatebearings (inner diameter of 8 mm) and press them onto the stud - (if very tight, sand a little bit). These can be found very cheaply on ebay. Use the screw to adjust width. Secure knob with glue. The design should fit most spools - write me a comment if you have any questions or suggestions. Happy printing
Frequently asked questions
- Is this 3D model free to download?
- Yes. Filament Spool Holder - Bearings and custom width is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by sigshoj.
- Who made this model?
- Designed by sigshoj, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Filament
