Case for ESP32 S2 Mini and LD2410C
Source: MakerWorld by TheProjectWheel
The Case for ESP32 S2 Mini and LD2410C is a free printable 3D model from MakerWorld by TheProjectWheel. A simple case for using an LD2410C radar sensors with an ESP32 S2 Mini. You can download the STL file from the original listing below and print it at home.
About this model
A simple case for using an LD2410C radar sensors with an ESP32 S2 Mini. I've included a little spacer that can be slid over the pins of the LD2410C to help with soldering to the ESP board. The lid has a cutout for the light sensor and the case body has holes for accessing the reset and programming mode buttons. BOM (affiliate links):S2 MiniLD2410CUSB CableI use these short and these long cables.Something to mount them to the wall with:My preference is Gorilla Putty but a small Command strip should work just as well.I'm using the this YAML configuration to integrate with Home Assistant.PrintSlide the spacer over the pins on the LD2410CSolder the LD2410C to the ESP32.Trim the pins on the back of the ESP32 as flush to the board as possible.Slide the board into the case:Put the side with the r…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Case for ESP32 S2 Mini and LD2410C is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by TheProjectWheel.
- Who made this model?
- Designed by TheProjectWheel, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in homeassistant
More from TheProjectWheel
