Puzzle of Evil - 2.0
Source: MakerWorld by hairyfacedhooman
The Puzzle of Evil - 2.0 is a free printable 3D model from MakerWorld by hairyfacedhooman. This Evil Puzzle will keep you busy for many many hours!Simply place the four puzzle pieces within the available space.Sounds pretty easy, doesn't it?With both an easy and a hard. You can download the STL file from the original listing below and print it at home.
About this model
This Evil Puzzle will keep you busy for many many hours!Simply place the four puzzle pieces within the available space.Sounds pretty easy, doesn't it?With both an easy and a hard option, no matter your ability, you should find some enjoyment and satisfaction with this small puzzle.The folding clamshell puzzle can happily hold all four of the pieces even if you've not managed to complete the puzzle, so is perfect to pop in your pocket, bag or keep on your desk.Printing and assembly advice:Each part can be printed in one piece, without the need for supports.The hinge uses a length of filament to fasten the two sides together, with the two hinge pins capping off each side. You may need a little CA glue to keep them in place.The magnets required are 6x2mm - the same used by GridfinityThese are…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Puzzle of Evil - 2.0 is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by hairyfacedhooman.
- Who made this model?
- Designed by hairyfacedhooman, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in puzzle
