Hypermobility Finger Splint
Source: MakerWorld by Jazzy Plz
The Hypermobility Finger Splint is a free printable 3D model from MakerWorld by Jazzy Plz. The base model is a size 10 and I went through and did test prints to get as close as I could to general ring sizes to make things easier for folks to print. You can download the STL file from the original listing below and print it at home.
About this model
The base model is a size 10 and I went through and did test prints to get as close as I could to general ring sizes to make things easier for folks to print. You may need to adjust as you see fit for shrinkage and other things but as it stands, it is close enough for a base! These types of rings are used for all manner of finger issues but is generally seen for hypermobility, EDS (Ehlers-Danlos syndrome), trigger finger, swan neck, etc. I have personally done them in resin, PLA, and PETG. You can generally fir two of these per finger.Ring Size 4: 75%Ring Size 4.5: 77%Ring Size 5: 80%Ring Size 5.5: 82%Ring Size 6: 83.5%Ring Size 6.5: 85%Ring Size 7: 88%Ring Size 7.5 : 89.5%Ring Size 8 : 90%Ring Size 8.5 : 95%Ring Size 9: 96.5Ring Size 9.5: 98%Ring Size 10: 100%Ring Size 10.5: 102%Ring Size …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Hypermobility Finger Splint is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by Jazzy Plz.
- Who made this model?
- Designed by Jazzy Plz, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in finger
