SD and micro SD keychain
Source: MakerWorld by sagat
The SD and micro SD keychain is a free printable 3D model from MakerWorld by sagat. If you like my design please don't forget to give me a boost! Keychain to insert micro SD and SD cards, it has internal holes to insert 6mm x 2mm magnets, (The magnets are inside. You can download the STL file from the original listing below and print it at home.
About this model
If you like my design please don't forget to give me a boost! Keychain to insert micro SD and SD cards, it has internal holes to insert 6mm x 2mm magnets, (The magnets are inside the piece, you have to insert a pause in the laminator and place the magnets. Think about how to place the magnets so that when you close north and south they are in the correct position) be careful with the polarity and think very carefully about the placement to insert the magnets so that later when assembling the keychain they attract each other and the keychain closes well You will need:M3 screws and nuts, the length will depend on how many layers you are going to put on your keychain) with 3 inner layers your keychain will have a total length of 19mm.then the thread length (L) of your screw should be approxim…
Frequently asked questions
- Is this 3D model free to download?
- Yes. SD and micro SD keychain is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by sagat.
- Who made this model?
- Designed by sagat, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in sd card
More from sagat
