Bambu Lab P1 Series Top Panel On-Off Switch
Source: MakerWorld by TDC-3D
The Bambu Lab P1 Series Top Panel On-Off Switch is a free printable 3D model from MakerWorld by TDC-3D. This is a Re-Mix of nyx_nk's Bambulab P1P/P1S USB LED. You can download the STL file from the original listing below and print it at home.
About this model
This is a Re-Mix of nyx_nk's Bambulab P1P/P1S USB LED. check is model out too! I made it only as an on-off switch and you can mount your leds where ever and or control whatever you want with this switch using the little vent hole on the top right off the P1 Series. I made it us a latching switch from amazon and a usb strip from amazon also. The on-off switch uses the top vent hole on the P1 series. This model does require a M4 brass heat insert and a M4 x 6mm screw.There is a wire channel to route the one wire through to connect to the switch. The latching switch is rated at 1.5amp which is the same amp rating on the front USB port. So you can use that to power the led strip. You will need to know how to solder and wire to install this and these are not the best install instructions as…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Bambu Lab P1 Series Top Panel On-Off Switch is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by TDC-3D.
- Who made this model?
- Designed by TDC-3D, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in bamblulab
More from TDC-3D
