Gridfinity Baseplate Magnet Jig
Source: MakerWorld by gsingh2011
The Gridfinity Baseplate Magnet Jig is a free printable 3D model from MakerWorld by gsingh2011. A remix of schneems design. You can download the STL file from the original listing below and print it at home.
About this model
A remix of schneems design. This is for installing magnets into baseplates, for installing magnets into bins see this project instead. Two problems I ran into with the original design were glue getting on the jig separator where the magnets are placed and accidentally rocking/tilting the jig when lifting up the magnet part. This remix replaces the four cylindrical locations where the magnets are placed with some small “bumps”, which reduces the likelihood of glue getting on them, and even if glue does get on them it's less likely to cause any problems because of the reduced surface area. The second change is that there are some small stabilizers added to the outer rim of the jig. When lifting up the magnet part of the jig, your fingers are usually holding the other part down by its edges. …
Frequently asked questions
- Is this 3D model free to download?
- Yes. Gridfinity Baseplate Magnet Jig is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by gsingh2011.
- Who made this model?
- Designed by gsingh2011, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in gridfinity
