Wall Mount Vinyl Record Holder
Source: MakerWorld by Fur Missile Prints
The Wall Mount Vinyl Record Holder is a free printable 3D model from MakerWorld by Fur Missile Prints. Boost MeIf you found this useful, don't forget to boost and follow me!Vinyl Record Display holder. You can download the STL file from the original listing below and print it at home.
About this model
Boost MeIf you found this useful, don't forget to boost and follow me!Vinyl Record Display holder. This design uses a single screw to hold up the record holder. The screw should go into either a wall stud or a drywall plug to provide rigid and adequate support. This allows for easy levelling while providing more than enough strength to prevent the records from falling off the wall as can happen with command strip mounts. This record holder has a relief cut in the back designed to hide the drywall plug. Relief will cover any plug with a head under 10mm and under 1mm thickness. This should be most of your standard 15lb and smaller drywall plugs. For best results use a screw inside the plug with a chamfered head so that it sits flush on your holder.Total length is 139mmTotal height is 36.5mmT…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Wall Mount Vinyl Record Holder is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by Fur Missile Prints.
- Who made this model?
- Designed by Fur Missile Prints, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in vinyl records
