3-4" duct connector (No supports needed)
Source: MakerWorld by ViceroySyrup
The 3-4" duct connector (No supports needed) is a free printable 3D model from MakerWorld by ViceroySyrup. Very basic model, fully printable, for 4" to 3" ducts.Made because I needed to connect my exhaust of my printer to my current dryer exhaust. You can download the STL file from the original listing below and print it at home.
On a computer?
Scan with your phone to install the free app.
About this model
Very basic model, fully printable, for 4" to 3" ducts.Made because I needed to connect my exhaust of my printer to my current dryer exhaust.
Frequently asked questions
- Is this 3D model free to download?
- Yes. 3-4" duct connector (No supports needed) is free to download from MakerWorld. Open it in the free Thinger app, or use the "Download from MakerWorld" link above to open the original listing.
- Where is the STL hosted?
- The download is hosted by MakerWorld, not by Thinger. We link you directly to the original listing by ViceroySyrup.
- Who made this model?
- Designed by ViceroySyrup, published on MakerWorld. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in 4
Porte Savon et Shampoing, douche minimaliste
MakerWorld · Grognatou
Jigsaw candle holder
MakerWorld · JaySavage210
Venosauro chica leia a descrição
MakerWorld · wub rara
Hydro Agent Gun Leg | Dummy 13 & Carbon 13
MakerWorld · Ollie's Agency Equipment
Industrial Girder Set D, Modular Terrain
MakerWorld · The Terrain Atelier
TRAMA |IKEA FEJKA da 6 cm
MakerWorld · Kentar
