Quick Change Filament Filter
Source: Thingiverse by rcolyer
The Quick Change Filament Filter is a free printable 3D model from Thingiverse by rcolyer. This is a fully parametric quick-change filament filter designed to keep dust on the filament from getting into your extruder and clogging it. You can download the STL file from the original listing below and print it at home.
About this model
This is a fully parametric quick-change filament filter designed to keep dust on the filament from getting into your extruder and clogging it. This was inspired by the CreativeTools Universal Filter, but trying to shove a sponge into that closed filter didn't make sense to me. So instead I used OpenSCAD to design a two-piece threaded filter that screws together, and put slits on the side so it could be slipped onto and off of the filament without even needing to disconnect from the extruder. Then I added tabs on the side so it could still easily be unscrewed even if it ends up with a little lubricating oil on the side. After creating this I found Kezat's filter which follows the same philosophy, so I listed this as a remix since he had the idea first. I added a 1.75mm and a 3mm version, si…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Quick Change Filament Filter is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by rcolyer.
- Who made this model?
- Designed by rcolyer, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Quick
