Is this 3D model free to download?

Yes, Wire Twister Tool for Drill (Up to 6 Wires) is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by grafmar, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Wire Twister Tool for Drill (Up to 6 Wires) 3D printable model by grafmar

Wire Twister Tool for Drill (Up to 6 Wires) photo 1

Wire Twister Tool for Drill (Up to 6 Wires) photo 2

Wire Twister Tool for Drill (Up to 6 Wires) photo 3

Wire Twister Tool for Drill (Up to 6 Wires) photo 4

Wire Twister Tool for Drill (Up to 6 Wires)

Source: Thingiverse by grafmar

The Wire Twister Tool for Drill (Up to 6 Wires) is a free printable 3D model from Thingiverse by grafmar. This tool helps you create neat, evenly twisted wire bundles using a cordless drill. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-10-30 License: CC-BY-SA · commercial OK Category: Tools & Workshop

Tags: cable management, cable twister, cable twisting, diy, DIY electronics, drill tool, electronics, Jig, maker, twisted cable, twisted wire, wire twister, wire twisting tool, wiring

About this model

This tool helps you create neat, evenly twisted wire bundles using a cordless drill. It can hold up to six wires with a diameter of approximately 3 mm each. Place each wire into one of the grooves and secure it with the locking ring to prevent it from slipping out during twisting. An M3 threaded standoff is mounted in the center of the tool and serves as the shaft for the drill. A standard M3 standoff and an M3 screw longer than 35 mm are recommended for assembly. To use the tool: 1. Secure one end of the wires in a vise or another suitable fixture. 2. Insert the wires into the grooves and lock them with the ring. 3. Clamp the standoff in a cordless drill. 4. Rotate the tool slowly until the desired twist is achieved. For the best results, periodically stop and allow the wires to untwist s…

Frequently asked questions

Is this 3D model free to download?: Yes. Wire Twister Tool for Drill (Up to 6 Wires) is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by grafmar.
Who made this model?: Designed by grafmar, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.