Long range yagi antenna for Q-X7
Source: Thingiverse by thegreen4me
The Long range yagi antenna for Q-X7 is a free printable 3D model from Thingiverse by thegreen4me. Link to purchase finished antenna with copper already installed: This is version 2. You can download the STL file from the original listing below and print it at home.
About this model
Link to purchase finished antenna with copper already installed: This is version 2. If you previously printed version 1, you should consider replacing it. The prior version was just based on dimensions from a questionable online calculator. This version however was fine tuned experimentally. Print this out and get some single strand copper wire exactly 1mm thick (basically 18 awg). Strip the insulation off, slide it into the holes on the print, and then cut the copper wire at the ends so it's the exact same length as that part of the print. Then just slide it over your q-x7's antenna, point in the direction you want to fly, and go! Important Note: If you have a hard time fitting the copper wires in, DO NOT scale the print larger; you will change the frequency of the antenna. Instead just g…
Frequently asked questions
- Is this 3D model free to download?
- Yes. Long range yagi antenna for Q-X7 is free to download from Thingiverse. Click the "Download free STL" button above to open the original listing.
- Where is the STL hosted?
- The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by thegreen4me.
- Who made this model?
- Designed by thegreen4me, published on Thingiverse. Please credit the creator when sharing your print online.
- Can I print this at home?
- Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.
Similar 3D models in Long
![Nerf Pyragon Picatinny Grip Attachment [Long ] 3D model](https://cdn.thingiverse.com/renders/f3/da/bb/a0/63/cebab4a6357da7b1a73632730e7dfc34_preview_card.jpg)
