Is this 3D model free to download?

Yes, Card Stand Kit in a Card-form is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link to open the original listing by the creator.

Where do I download the STL file?

The download is hosted by Thingiverse. Use the "Download from Thingiverse" link on this page to open the original listing and grab the file, or save it to your print queue in the free Thinger app.

Designed by LemonPanda72, published on Thingiverse. Please credit the creator when sharing your print.

Can I print this at home?

Yes. This is a printable 3D model intended for home FDM and resin printers. Check the original listing for suggested print settings.

Card Stand Kit in a Card-form 3D printable model by LemonPanda72

Card Stand Kit in a Card-form

Source: Thingiverse by LemonPanda72

The Card Stand Kit in a Card-form is a free printable 3D model from Thingiverse by LemonPanda72. Two flat pieces that nest into one credit-card-sized card, so the whole stand rides in your card case next to your business cards. You can download the STL file from the original listing below and print it at home.

Open in Thinger (free) Download from Thingiverse

30 saves Source: Thingiverse Updated 2026-11-03 Filament: 7 g License: CC-BY-NC · non-commercial Category: Office

Tags: businesscard, businesscardholder, cardholder, cardstand, creditcardsize, desk, EDC, flatpack, noglue, office, walletsize

About this model

Two flat pieces that nest into one credit-card-sized card, so the whole stand rides in your card case next to your business cards. Slot them together and you have an X-frame stand for the cards themselves. What you get - Two parts that nest into a single card measuring 85.5 x 53.9 x 1.2 mm, the standard credit card footprint - Slots together into an X-frame stand with a cross-lap joint: no glue, no screws, no hardware - The slot is 1.2 mm wide and 12.5 mm deep with a flared mouth, so the halves guide themselves in - Every edge is chamfered 0.3 mm, so it handles like a card, not a printed part - Both parts together use about 5.4 cm3 of filament, roughly 6.7 g in PLA Fit check - The nested card is 85.5 x 53.9 mm against the ISO ID-1 card standard of 85.6 x 54.0 mm, so it drops into a card ca…

Frequently asked questions

Is this 3D model free to download?: Yes. Card Stand Kit in a Card-form is free to download from Thingiverse. Open it in the free Thinger app, or use the "Download from Thingiverse" link above to open the original listing.
Where is the STL hosted?: The download is hosted by Thingiverse, not by Thinger. We link you directly to the original listing by LemonPanda72.
Who made this model?: Designed by LemonPanda72, published on Thingiverse. Please credit the creator when sharing your print online.
Can I print this at home?: Yes. This model is intended for home FDM and resin 3D printers. Check the original listing for suggested print settings like layer height and supports.